Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • towe's Avatar
    03-04-2020, 02:45 PM
    Quick update: #1 FLEXCAN3_RX (pad 30) goes to RXD on the MCP2558FD, FLEXCAN3_TX (pad 31) goes to TXD - and works perfectly. #2 I went with soldering thin wires on the pads. My Teensy has regulator breadboard headers...
    4 replies | 230 view(s)
  • towe's Avatar
    03-03-2020, 06:14 AM
    Well that's a much easier fix than my .bat file - thank you! Windows privileges are a book of mysteries of their own, I'd never have expected something so absurd. It doesn't seem to apply in that same way to any...
    14 replies | 1877 view(s)
  • towe's Avatar
    02-28-2020, 06:32 AM
    Works fine with 1.8.12 on Windows 10 1809 64-bit. Still """requires""" admin rights though.
    14 replies | 1877 view(s)
  • towe's Avatar
    02-20-2020, 08:29 AM
    I've finally got all my hardware in place so I can start testing - but I've run into an issue. I can't seem to receive frames with BRS enabled on my Teensy. As soon as I enable that bit (in CANalyzer 11 Pro's...
    185 replies | 12917 view(s)
  • towe's Avatar
    02-05-2020, 12:03 PM
    Admin-less installation on Windows 10 64-bit over Arduino IDE 1.8.11 worked fine. The bug with the supposedly required admin rights - probably for installing USB drivers on obsolete Windows versions - is still there...
    59 replies | 3477 view(s)
No More Results
About towe

Basic Information


Total Posts
Total Posts
Posts Per Day
Last Post
Teensy 4.0 CAN-FD pin direction and pad connection 03-04-2020 02:45 PM
General Information
Last Activity
03-09-2020 07:30 AM
Join Date