Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
mah's Activity
About Me
Tab Content
  • mah's Avatar
    07-06-2020, 01:42 PM
    "Since this chip is a special bi-directional level shifter it does not have strong output pins that can drive LEDs or long cables, it's meant to sit on a breadboard between two logic..." I guess a gate would draw very...
    4 replies | 248 view(s)
  • mah's Avatar
    07-06-2020, 01:14 PM
    Yeah, I know Paul suggested that the some of those was not a good option for some applications, but don't remember the specifics right now. Maybe it will be fine
    4 replies | 248 view(s)
  • mah's Avatar
    07-06-2020, 12:50 PM
    Hi, I'm want to send and receive eurorack/synth gates with a teensy 4.1, the gates should be 5v but as the teensy is 3.3 v so I need to shift both up and down, and I also want to use software to change if a pin should...
    4 replies | 248 view(s)
  • mah's Avatar
    07-04-2020, 09:29 PM
    wow thx! cleared up quite a lot of things! Just to be clear, this should theoretically be the most efficient method of connecting SPI devices? --------------------- SPI0: MISO0 MOSI0 SCK0 CS0 CS0-1
    3 replies | 182 view(s)
  • mah's Avatar
    07-04-2020, 06:13 PM
    I'm using a teensy 4.1, and got some questions about SPI: Is it possible to use both "miso,mosi,sck,cs" (pins: 12,11,13,10) and "miso1,mosi1,sck1,cs1" (pins: 1,26,27,0) at the same time? connected to different...
    3 replies | 182 view(s)
  • mah's Avatar
    07-02-2020, 05:09 PM
    Thanks, i was just wondering, this might be a bad idea to, but if i connected busy to CNV, would that make it do a conversion every time its not busy?
    3 replies | 133 view(s)
  • mah's Avatar
    07-02-2020, 09:45 AM
    Hi, I'm using a LTC2335-16 ADC in a project and I am a bit confused about what to do with the CNV input, from what I read the ADC conversation happens when the ADC gets input on the cnv pin, should I tie it to CS or...
    3 replies | 133 view(s)
  • mah's Avatar
    06-30-2020, 10:36 AM
    mah replied to a thread T4.1 Ethernet board in General Discussion
    Yeah, thanks, could not find a schematic so i looked at other schematics. gonna remove the 3.3v, and the resistor. Dont know much about the SI-46001-F either, just picked it because i needed a vertical jack, and it...
    20 replies | 3234 view(s)
  • mah's Avatar
    06-29-2020, 06:04 PM
    mah replied to a thread T4.1 Ethernet board in General Discussion
    Is this right? :confused:
    20 replies | 3234 view(s)
No More Results
About mah

Basic Information

Statistics


Total Posts
Total Posts
14
Posts Per Day
0.15
Last Post
True bidirectional logic level shifter 07-06-2020 01:42 PM
General Information
Last Activity
08-02-2020 05:39 PM
Join Date
05-08-2020