Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • garcho's Avatar
    08-21-2020, 10:28 PM
    works like a charm and made wiring a breeze, thanks again y'all
    12 replies | 382 view(s)
  • garcho's Avatar
    08-03-2020, 05:21 PM
    I did indeed get the correct ICs. Thanks much for the advice, and thank you Mark for untying my tongue!
    12 replies | 382 view(s)
  • garcho's Avatar
    08-03-2020, 03:32 PM
    Thanks for the suggestions y'all, I ordered some '541s. So, as long as OE1 and OE2 are held to ground, all inputs will be non-inverting buffers?
    12 replies | 382 view(s)
  • garcho's Avatar
    08-02-2020, 08:39 PM
    "I'd use 74HCT244 as an octal buffer" I'm not familiar with those. Would it be something like this: I am assuming I should not connect the Teensy pins directly to the buffer. What value of resistor should I use...
    12 replies | 382 view(s)
  • garcho's Avatar
    08-02-2020, 06:43 PM
    I have a MIDI master clock ready to be built but for the final few pieces of the puzzle. If I have 8 UART outputs going to 8 MIDI jacks, should I buffer each with a pair of inverters? Or will a 47Ω resistor in...
    12 replies | 382 view(s)
No More Results
About garcho

Basic Information

About garcho
Location:
Richmond, VA

Statistics


Total Posts
Total Posts
9
Posts Per Day
0.08
Last Post
8 MIDI outs, hardware 08-21-2020 10:28 PM
General Information
Last Activity
09-20-2020 08:31 PM
Join Date
05-26-2020