Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • MeBoop's Avatar
    06-21-2020, 01:42 AM
    Update since I can't edit my post(?) -- The WINC1500 WiFi module I'm using seems to behave despite the RA8875 not being tristate and there has been no issues after running both in tandem for ~an hour (just outputting...
    8 replies | 405 view(s)
  • MeBoop's Avatar
    06-20-2020, 08:47 PM
    Aw man, double checked the solder joint and I'm not shorting it, that would've been a huge relief. At this point I might just order another teensy, would prefer that to using an additional chip to babysit the rude...
    8 replies | 405 view(s)
  • MeBoop's Avatar
    06-20-2020, 05:39 PM
    I think my pin may just be foobarred :( So I don't have to wait for a replacement to ship, does anyone have a suggestion on "soft coding" a circumvention for the non tristate SPI board I'm interacting with? For...
    8 replies | 405 view(s)
  • MeBoop's Avatar
    06-20-2020, 04:10 PM
    I'm aware -- SPI not functioning is how I figured out this was happening in the first place I'm using the blink sketch here -- look how wonky the signal is. For reference, here's blink on pin 14:
    8 replies | 405 view(s)
  • MeBoop's Avatar
    06-19-2020, 08:15 PM
    Hi! I'm seriously enjoying my 4.1, but I've run into a bit of a conundrum. My pin 13 is very noisy and only goes up a couple millivolts (confirmed via scope) when I set it to HIGH. This is particularly problematic...
    8 replies | 405 view(s)
No More Results
About MeBoop

Basic Information

Statistics


Total Posts
Total Posts
5
Posts Per Day
0.09
Last Post
Pin 13 Problem on Teensy 4.1 06-21-2020 01:42 AM
General Information
Last Activity
Yesterday 03:01 PM
Join Date
06-16-2020