Hi All,
I have an 8 x 8 button matrix that works fine when a single button is pressed. It also works fine when about 15 buttons are pressed and held. However after that amount, it starts to become unstable and I get button triggers from adjacent...
Hi all.
I have the following code but i don't know how to implement it. I want to assign all these pins as follows:
<
IOMUXC_SW_PAD_CTL_PAD_GPIO_AD_B1_04 |= IOMUXC_PAD_SPEED(1) | IOMUXC_PAD_DSE(7) | IOMUXC_PAD_SRE(0)...
Hi Chris and Tom, would you mind explaining in a bit more detail the syntax so that I can change the slew rate and drive strength on specific output pins and please point me to the information i need in the manual ie where the PAD gpio addresses...