I have a project in which I am powering a Teensy 4.0 with 5V directly from a power supply and I have the trace cut so I can still use the USB for acquiring data over serial. I noticed recently that when I programmed or...
I will probably upload the files and/or post it on OSHPark. It requires hot air, good soldering skills and flux.
I would love if they did this. I feel as if they are waiting until they make the switch from...
I have been working on a Teensy 4.1 debugger mod for a month or so now and I figured it was in a good place to share my progress. This project started by de-soldering the MKL02 chip, soldering magnet wire onto each pin...
That's great Paul! I will be sure to use these for my board. Is there a recommended footprint for the header? I'm sure I could use a similar part's footprint and it would be fine but just to be safe. 0.7mm drill / 1.1mm...
No problem. Hope it is really as easy as swapping out a part rather than needing another pcb manufactured. I have been fine so far with user libraries, but it is always good to double check them for sure. Have fun with...
Thanks for the suggestion, this is what I am after for sure. I have not gotten around to making the next revision of my board yet but I will definitely consider these. Since I have posted this I found a few candidates...
Looking at the J0011D01BNL datasheet, it looks like the pinout is different between the J0011 and the J1B1211CCD that PJRC uses?
Here is the J0011
and J1B1211CCD
Cable side is the same but PCB side looks...
Find latest posts