Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • Spencez's Avatar
    09-05-2021, 06:47 AM
    Arduino CLI 0.19.0 was just released with support for pluggable discovery. This is good news, I assume Arduino CLI and Arduino IDE 2.0 Beta are finally ready for Teensy support. ...
    49 replies | 10581 view(s)
  • Spencez's Avatar
    08-19-2021, 08:21 PM
    That is a problem. Pin 10 should be pulled high by the MKL02. If this is LOW, I believe pin 9 will also be low which is your power on reset. This means the processor is being held in reset and it will not run your...
    196 replies | 37020 view(s)
  • Spencez's Avatar
    08-03-2021, 02:59 AM
    Are you powering it with a LiPo? I remember reading that the ESC has regenerative braking and it could damage a power supply so you had to use a LiPo to power it. If so disregard, I just remember reading the warning.
    11 replies | 709 view(s)
  • Spencez's Avatar
    07-31-2021, 04:49 AM
    You could try his code before going ahead and buying one although he explains how he only could get it to work with a KISS ESC, not sure the reason. It should work on either of your Teensy versions, I would follow the...
    11 replies | 709 view(s)
  • Spencez's Avatar
    07-31-2021, 03:13 AM
    Are you using a KISS ESC? If so, Give this a shot. https://sbasami-tech.hatenablog.com/entry/2020/08/23/095106 Specifically this ino. https://gist.github.com/sbasami/06c419e61e01a2bc9e5d60622069f288 He used a...
    11 replies | 709 view(s)
  • Spencez's Avatar
    07-30-2021, 06:41 AM
    Did you try pin 4? It looks like ESC 1 should be on pin 4 according to the readme on github. Sorry for the simple question, I will try and look deeper into it tomorrow. Which version Teensy are you using? It's...
    11 replies | 709 view(s)
  • Spencez's Avatar
    07-30-2021, 06:14 AM
    How far did you get with attempting to use the teensyshot library? At first glance it looks as if once you load the program on to the Teensy you need to write a program on the pc which sends data to the Teensy over usb...
    11 replies | 709 view(s)
No More Results
About Spencez

Basic Information

Statistics


Total Posts
Total Posts
22
Posts Per Day
0.08
Last Post
Arduino CLI Alpha Release - Teensy Support? 09-05-2021 06:47 AM
General Information
Last Activity
Yesterday 04:48 PM
Join Date
12-16-2020