Forum Rule: Always post complete source code & details to reproduce any issue!
Tab Content
  • domingo's Avatar
    07-22-2022, 04:45 PM
    domingo replied to a thread Ak4384 dac i2s in Project Guidance
    Hey Paul and everyone, So this DAC works, but I get rushes of noise that I've tried everything to solve. Resistors of many magnitudes (below 470R) across the I2S lines, all decoupled as per datasheet. Same happens...
    6 replies | 190 view(s)
  • domingo's Avatar
    07-18-2022, 08:53 PM
    domingo replied to a thread Ak4384 dac i2s in Project Guidance
    Thank you for your time Paul. It was quite a revelation for me that 'parallel' meant only pins L and H. I tried already in a few occasions what you mention, following the datasheet as well. The signal seems to be there...
    6 replies | 190 view(s)
  • domingo's Avatar
    07-18-2022, 05:52 PM
    I'm using some TDA1387 chips in parallel with the Teensy 3.6 since some time. The sound is very good, this chip as many other NOS DACs is known for its soundstage and natural sounding, but lack of detail can be a bit...
    0 replies | 100 view(s)
  • domingo's Avatar
    07-14-2022, 11:46 PM
    domingo replied to a thread Ak4384 dac i2s in Project Guidance
    Thank you. Sounds like I would need to wire pin8 (DIF0) to a digital pin in the teensy and write the code to set the mode, but I have no experience on that. Is there any copy paste from code from a similar device I...
    6 replies | 190 view(s)
  • domingo's Avatar
    07-14-2022, 07:55 PM
    Hi all, I've got this chip AK4384 while disassembling an old Tascam interface. I placed it on an adapter and connected everything I could, but it doesn't work. I think it is not set to I2S mode. The data sheet says...
    6 replies | 190 view(s)
No More Results
About domingo

Basic Information

Statistics


Total Posts
Total Posts
39
Posts Per Day
0.09
Last Post
Ak4384 dac i2s 07-22-2022 04:45 PM
General Information
Last Activity
07-23-2022 05:01 AM
Join Date
05-13-2021