To make Teensy2++ last longer, should I unplug it every time after experiment? Is it OK to unplug while the programing is running? Should I put PC at sleep mode when not using and leave Teensy connected?
Hi all,
I changed the Teensy and everything is working. Here are some catch-up questions or consultations to make this Teensy last longer. A kind reminder: Teensy2++, Win10. In my case, there is only one program I...
It worked before and after soldering. I also programed it for many times before and after soldering. Would it be possible that programming will damage it, since I programed it for dozens of times?
Any ideas about how to test what's going wrong?
I have extra new Teensy ++2 which could be detected by PC. However the not-detected Teensy is soldered on board, so it will be a pain if de-solder and replace the new...
Sure, I will send a picture tomorrow, but it looks the same as that on the official website, at least from the top view. I don't know how to tell truth. By the way, there is no stock on official website. Where to buy...
Hi KurtE,
Thanks for your advice. I will measure resistance between power and ground. Others have been tried, but maybe I will try multiple times. Any idea what may damage the teensy?
Best
This teensy2++ worked well before, but are not recognized by PC today, so it cannot be genuine before and turn to fake today, right? By the way, I have went through other similar posts and tried many different methods...
To add more details. I used Windows10. I tried to upload the Blink example, it shows
Binary sketch size: 2,750 bytes (of a 130,048 byte maximum)
Estimated memory use: 24 bytes (of a 8,192 byte maximum)
Teensy did...
Hi,
The Teensy 2++ was recognized by PC before, but today it is not. It doesn't run the program when I press the button. There is power (5V) detected from the Teensy board, which means the connection should be fine....
Find latest posts