farhantandia
Member
Hi all,
I just testing my new Radio freq. modules (915Mhz) to my arduino uno and its work fine, send the data to the RF receiver in my pc using teraterm correctly .
but when i switch using my teensy 3.2, the data i received is nonsense (error).
this is source code that i used to
//SoftwareSerial print_serial(0,1); using arduino uno
#define print_serial Serial3 // using teensy 3.2, i also have tried with serial1 and output still uncorrect.
void setup() {
print_serial.begin(57600);
Serial.begin(57600);
delay(1000);
}
void loop() {
Serial.println('b');
print_serial.println('b');
delay(1000);
}
Note :
-COM4 is the teensy serial, and COM3 is the RF receiver in my PC.
-Baudrate already set to 57600 in teraterm and teensy.
any suggestion or my simple SC is still wrong? thanks all.
I just testing my new Radio freq. modules (915Mhz) to my arduino uno and its work fine, send the data to the RF receiver in my pc using teraterm correctly .
but when i switch using my teensy 3.2, the data i received is nonsense (error).
this is source code that i used to
//SoftwareSerial print_serial(0,1); using arduino uno
#define print_serial Serial3 // using teensy 3.2, i also have tried with serial1 and output still uncorrect.
void setup() {
print_serial.begin(57600);
Serial.begin(57600);
delay(1000);
}
void loop() {
Serial.println('b');
print_serial.println('b');
delay(1000);
}
Note :
-COM4 is the teensy serial, and COM3 is the RF receiver in my PC.
-Baudrate already set to 57600 in teraterm and teensy.
any suggestion or my simple SC is still wrong? thanks all.