Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: Arctic_Eddie

Search: Search took 0.00 seconds.

  1. Replies
    18
    Views
    6,765

    Here's my calibrate procedure. Use a pointed...

    Here's my calibrate procedure. Use a pointed plastic or wooden stylus and locate the touch screen values for the upper-left and lower-right corners centered over each of the two small white squares....
  2. Replies
    18
    Views
    6,765

    On which side of the display is the row of pins...

    On which side of the display is the row of pins located when setRotation(0) is set to? The header file shows width as 240 and height as 320. This is reverse from what I expected. I'm using...
  3. Replies
    18
    Views
    6,765

    I'm also working on a cal procedure sketch. Give...

    I'm also working on a cal procedure sketch. Give me another 30 minutes.
  4. Replies
    18
    Views
    6,765

    I don't see any calibration points in the library...

    I don't see any calibration points in the library files. Later today, I'll determine the values for my display and put a label on the back for reference. In my code, I'll map the raw screen...
  5. Replies
    18
    Views
    6,765

    The touch example uses setRotation(1) while the...

    The touch example uses setRotation(1) while the DemoSauce uses (3) so that explains the difference. If the touch coordinates start at the upper-left corner then setRotation(1) appears to be the one...
  6. Replies
    18
    Views
    6,765

    I just installed the XPT2046 library and got the...

    I just installed the XPT2046 library and got the same results as you. That at least confirms my hardware is working correctly. The other failed example with the colored squares does not work and I...
  7. Replies
    18
    Views
    6,765

    I'm using the one mentioned in your product link...

    I'm using the one mentioned in your product link and originally the library in TeensyDuino 1.31. However, both fail to run the touch test successfully. I'm using the pin connections mention just...
  8. Replies
    18
    Views
    6,765

    ILI9341_t3 Touch Screen Trouble

    I just got my PJRC display with touch screen yesterday. It's now wired up to a T36 and tested. All of the graphic tests work but none of the touch screeen. I am using IDE 1.6.12, TyQt, and the...
Results 1 to 8 of 8