Search:

Hi jonr,

I am sending the method that fails, as I have previously mentioned I am using the ArduinoJSON library, then the Error I get its managed by their library, and it returns an error of the...

Dear PJRC community,

I am working on a project that embeds multiple methods, most of them are configurable. This processing methods are used in conjunction of acquired sensor measured data, in...

Dear PJRC Community,

I have find the issue it was a bad placement of one component in the assembly, please delete this thread.

Thanks,

Dear PJRC Community,

We have a prototype project that require a rigid flex PCB design. It implies a custom Teensy 3.2 board. We have already some experience with rigid Custom Teensy 3.2 with...

Dear Paul,

I am using the 3.3V output from the Teensy to power other components that are using current, so it seems to explain my issue. I understand that I might improve the power line ciruict. ...

Dear PJRC Community,

I have not received any reply, I understand that I might publish the complete source code, while I am not able to publish it, I have identified a part of the code that seems...

Dear PJRC Community,

I am trying to migrate Teensy 3.2 projects into the new Teensy 4.0, ideally using the same arduino firmware with compatible libraries should be compatible, and the performance...

Thanks luni!

I will use your library.

Thanks for the fast reply, I want to be able to enable or disable this options for the GPIO, so as I could understand, if I want to modify this I can directly modify the CORE_PIN#_CONFIG register...

Dear PJRC community,

We have a project based on the Teensy 3.6, we would need to modify or configure the Drive Strength Enable DSE and the Slew Rate Enable SRE options for a particular GPIO. As...

Dear Teensy comunity,

I would like to change the name of the device, I am using it in the USB Type: "Serial". When I upload the firmware into a Teensy 3.2, I get the device name: "USB Serial".
...

I wrote my own functions to read and it worked, so I did not need to use the HDC library and it works perfect.

Thanks for the support.

Thanks for the ideas,

Paul I am trying to use the ClosedCube HDC1080, I need to connect it to the i2c Wire1 interface on pins 29 and 30. ...

Dear Teensy Community,

I would like to use a humidity&temperature sensor which is controlled or acquired by i2c bus. I am trying to use the Arduino library in order to access to the sensor data. ...

Hello Everyone,

I am trying to communicate serially with the PC at 460800 bauds, in order to do it, I am connecting a FTDI circuit, and I am using the flow control signals CTS and RTS. I'm able...

Hi Paul,

I had a problem with my external source, it was giving a little overvoltage at start, I changed it and now it works.

Thanks for your fast support.

Regards.

The Teensy runs the code, and it looks that it retain the code, because I am using the simple /* LED Blink, Teensyduino Tutorial #1, however when I restart it, I found that the only way to see the...

Hi Paul,

In the Teensy 3.x schematics I find there are two nets named as VBAT, the external pin VBAT, and also the internal pin 21 of the Kinetis called VBAT. I have disconnected the external pin...

Thanks for the reply WMXZ,

I attach here the schematics.

9657

I found strange that the Teensy loads well the arduino sketch, but when I restart it, is missing anything, and only start...

Hi PJRC Team,

First of all I would like to mention that I find the Teensy project a very competitive solution for develop arduino projects. I have used teensy 3.2 for many projects, and I found a...