Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: stephanschulz

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    932

    Thank you both for your valuable input. For now...

    Thank you both for your valuable input.
    For now I will unplug the touch sensor and see if the teensy still overheats at points.
    But even went not doing touchRead() did it heat up to the point of...
  2. Replies
    9
    Views
    932

    I finally have physical access to the problem...

    I finally have physical access to the problem teensy / PCB setup.

    To re-cap.
    I am using PIN A8 as a capacity touch sensor. I have a 1.5 meter cable running to a 3D printed part that is covered in...
  3. Replies
    9
    Views
    932

    thanks pictographer. I thought I already took...

    thanks pictographer.

    I thought I already took care of most clamping via the constrain() function.
    But I will look it over again.

    In addition if move the touch code to processing to look for...
  4. Replies
    9
    Views
    932

    Thanks Paul for the quick reply. I certainly...

    Thanks Paul for the quick reply.

    I certainly agree that posting code help.
    Right now I only have the full project which has too much meat around the edges....
  5. Replies
    9
    Views
    932

    I learned that the max touchRead value returned...

    I learned that the max touchRead value returned is 65535.
    I am still not sure if it might also output -1 during an error; similar to the capacity touch library on the teensy site.

    I did apply...
  6. Replies
    9
    Views
    932

    teensy 3.2 touchRead() range ?

    Hello

    I have a few teensy 3.2 running in an exhibition and am using the touchRead to see if people are touching a pad.
    The touch pad is connected to pin A8 and it's readings are send out over...
Results 1 to 6 of 6