Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: anku

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    804

    Thanks, just ordered one! And thank you for...

    Thanks, just ordered one!

    And thank you for the welcome! For quite some time I've been looking for a project where the Nanos that are usually my go-to choice wouldn't be sufficient anymore. Coming...
  2. Replies
    10
    Views
    804

    Okay, thanks for the heads up. What would you...

    Okay, thanks for the heads up. What would you recommend instead? I wasn‘t planning on going higher than 24V on the input. 32V just seemed save..
  3. Replies
    10
    Views
    804

    Thank you for your advice! There seems to be no...

    Thank you for your advice! There seems to be no need for any 5V lines anymore, so I'll stick to 3.3V entirely.
    Do you have any recommendations for a reliable regulator? I was looking at the TSR...
  4. Replies
    10
    Views
    804

    Thanks for you answer! Ok, I think I was not...

    Thanks for you answer!

    Ok, I think I was not clear about that. I was talking about the stepper driver logic part being powered by the LC. The motor powering part on the drivers are directly fed by...
  5. Replies
    10
    Views
    804

    Teensy LC: power converter question

    Hello,

    coming from Arduino, this is my first project with a Teensy. I understand that the Teensy LC likes 3.3V on all pins, so all components connected must work at that voltage. The primary power...
Results 1 to 5 of 5