Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: CANHelp

Search: Search took 0.00 seconds.

  1. Replies
    22
    Views
    822

    It does not, no. Since we've set listen only...

    It does not, no. Since we've set listen only mode in setup, the send never occurs (even when told to progress through a Send / CAN TX), so it has no idea that there are other functioning devices on...
  2. Replies
    22
    Views
    822

    Sorry I'm not sure I understand what you mean, if...

    Sorry I'm not sure I understand what you mean, if I set the device to be listen only in setup, it'll never attempt to TX and never get into an infinite TX situation.
  3. Replies
    22
    Views
    822

    Very similar functionality to the previous test...

    Very similar functionality to the previous test on my end. I've only edited the wording for the second section. In the previous version you could return the teensy to sending valid TX's in scenario...
  4. Replies
    22
    Views
    822

    With your tpp modification: If Node A is...

    With your tpp modification:

    If Node A is active and sending ACK on Teensy boot, the teensy will function as expected on CAN TX.

    If Node A is active and able to send ACK on teensy boot and CAN...
  5. Replies
    22
    Views
    822

    I gave that a try, unfortunately it still floods...

    I gave that a try, unfortunately it still floods the BUS. In 10 seconds it recorded just under 48,000 transmits once the ACK error was generated. (I gave it 10 seconds then killed the process). I'm...
  6. Replies
    22
    Views
    822

    I appreciate you looking into it. I have a test...

    I appreciate you looking into it. I have a test bench built out with an aftermarket control unit and a diagnostic unit, both have switchable modes while I was testing this. Some of this may be...
  7. Replies
    22
    Views
    822

    Apologies, I don't like going to the web for help...

    Apologies, I don't like going to the web for help and when the first response was someone telling me I'm wrong, and to tell it "just not to transmit", after I'd been I'd been testing for a few days...
  8. Replies
    22
    Views
    822

    That's not accurate. I deal with CAN devices on...

    That's not accurate. I deal with CAN devices on a mostly daily basis, however in this case I wanted something cheap / off the shelf to use as an additional node. You can very easily have other...
  9. Replies
    22
    Views
    822

    FlexCAN - Infinite / Endless TX Retries

    Chipset : Teensy 3.2 / NXP MK20
    CANBUS Transceiver : SN65HVD230D

    I'm having an issue where if my 3.2 becomes isolated on the bus, and stops receiving a dominant ACK bit from other devices, it...
Results 1 to 9 of 11