Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: ratnin

Search: Search took 0.00 seconds.

  1. First off, the max baud rate isn't 115200 on the...

    First off, the max baud rate isn't 115200 on the Nextion. It's 921600 and I use this baud rate reliably in a production product. So, start with "baud=921600". Next, regarding the minimum timer delay...
  2. Can FlexNVM be used for additional program flash?

    I have an existing Teensy 3.2 based project that has been regularly updated over the past couple years to add an ever increasing list of features/capabilities. The constant stream of updates have...
  3. Replies
    2
    Views
    264

    I'm going to assume you've already worked out the...

    I'm going to assume you've already worked out the analog circuitry for handing your piezo signals (amplification, impedance) and that you're simply working on capturing and "replaying" incoming...
  4. Replies
    38
    Views
    1,302

    I believe you need to be looking for a list of...

    I believe you need to be looking for a list of PID's, preferably make/model specific. These serve to identify the different values and sensor readings accessible thru the CANBUS. Some of these are...
  5. Replies
    16
    Views
    1,293

    I suspect the market for 3.X will still be strong...

    I suspect the market for 3.X will still be strong for both new designs and existing/legacy products. The 3.2/3.5 are particularly well suited to certain applications (analog heavy, 5V tolerance, etc)...
  6. Replies
    7
    Views
    343

    From my experience you CAN damage other on-board...

    From my experience you CAN damage other on-board components when applying excess voltage to a Teensy GPIO when the voltage is large enough (~9-10V+), the circuit path to the pin does not have an...
  7. Replies
    3
    Views
    763

    This is what I use on 3.2 void loop() { ...

    This is what I use on 3.2



    void loop() {
    Serial.println("USB Status: ");
    while(1) {
    if(USB_Status()==0) { Serial.println(" NONE"); }
    if(USB_Status()==1) { ...
  8. Replies
    7
    Views
    2,838

    Below is basically the code that I've used for...

    Below is basically the code that I've used for some time. Works on Serial1/Serial2/Serial3 without issues. Automatically sets the max baud rate which makes for quick uploads. If you're using the...
  9. Not sure if this helps but your defines don't...

    Not sure if this helps but your defines don't match your code.

    You have:
    #define XSERIAL Serial1
    #define YESERIAL Serial2

    But your following code refers to YSERIAL
Results 1 to 9 of 9