Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: caggius

Search: Search took 0.00 seconds.

  1. I have TeensyControls 1.51 working on a Teensy...

    I have TeensyControls 1.51 working on a Teensy 4.0 with Arduino 1.8.12.
    Windows worked first time, but I had a few problems with Ubuntu caused by not reading the instructions....
    cheers Bob
  2. I do not pretend to understand what is going on...

    I do not pretend to understand what is going on here as everything I read says the X-Plane is very single threaded. I have just repeated the same flight on both OS and monitored processor/memory...
  3. OK my fault ! Not sure if it was needed but I...

    OK my fault !
    Not sure if it was needed but I added my user to the dialout group as this was reported in another sim group as a fix.
    But that post also pointed me to the...
  4. So I turned off network logging and all network...

    So I turned off network logging and all network io, ran all the graphics sliders and options to 0, set 2D panel & full screen, turned off vsync.
    I chose a new flight Cesnna 172 sat at the end of...
  5. Yep it is working in Windows, quick reboot into...

    Yep it is working in Windows, quick reboot into Linux and the same physical set up does not work.
    Xplane runs OK, it loads the correct plug in with no errors, Linux recognises the HID USB key, so I...
  6. Is Flight Sim Controls, X-Plane 11 and Teensy 4.0 fully supported and operational ?

    I have been playing with X-Plane and dataRefs for some time using ethernet connectivity and having run into performance problems with ATMEL controllers I have switched to the faster Teensy.
    Rather...
  7. Hi, did you resolve this and if so could you post...

    Hi, did you resolve this and if so could you post the solution, thanks Bob
Results 1 to 7 of 7