Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: ZackM

Search: Search took 0.00 seconds.

  1. Not rude at all. I'm asking because the example...

    Not rude at all. I'm asking because the example layout in the datasheet shows the transceiver being complimented by a handful of other components, but I've come across images/sketches/videos of...
  2. With RS485 do I need to include an extra node at...

    With RS485 do I need to include an extra node at the end of the chain that has a termination resistor?
  3. Generally speaking, do the RS485 transceivers...

    Generally speaking, do the RS485 transceivers connect directly to the 3.3v/GND/Tx/Rx pins on the Teensy and the A/B wires from the master, or are there other components that need to be integrated to...
  4. If I used the SN65HVD82 I would need to use a...

    If I used the SN65HVD82 I would need to use a Teensy that has 5v tolerant serial pins, correct?
  5. So if I go the RS485 route, can I start testing...

    So if I go the RS485 route, can I start testing with a USB to RS485 from my computer to a RS485 to UART at my microcontroller? Does the connection from the RS485 transmitter to the RS485 receiver...
  6. If the pins for the input and output are...

    If the pins for the input and output are connected to each other then the signal will just bypass the node if it goes bad, right? I'm thinking about it from a wire management standpoint. I'd prefer...
  7. From a physical wiring standpoint how does this...

    From a physical wiring standpoint how does this work? Does each microcontroller have an input and an output that just get daisy chained from cell to cell? Is there a preferred connection/wire type?
  8. I've purchased a few Teensy 4.0s for testing, but...

    I've purchased a few Teensy 4.0s for testing, but nothing is set in stone with regards to which one will be used in the final build. Whatever will work, I suppose.

    The messages will be fairly...
  9. Sending serial data to many Teensy boards at once.

    Hi all,

    I'm working on a concept that involves controlling an array of stepper motors (up to 100 in a 10x10 grid) at the same time. The idea is that a master controller (could be a pc or another...
Results 1 to 9 of 9