Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: K3FY

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    4,598

    Honestly I do not know what sort of I2C...

    Honestly I do not know what sort of I2C communication problem I ran into at that time. I would not worry about it though, the teensy handles I2C fine. Maybe I was just polling the external Adc too...
  2. Replies
    12
    Views
    4,598

    Long time follower of your project. Nice to see...

    Long time follower of your project. Nice to see you moving up to Teensy 3.6. I studied your code in the past. Very nice job. I completed a Teensy 3.6 project (hydraulic 4 wheel steering) which...
  3. Replies
    13
    Views
    1,644

    I have used this board with sucess. I still need...

    I have used this board with sucess. I still need to put a resistor across VR Sensor wires occasionally to get 100 % reads. http://jbperf.com/dual_VR/v2_1.html
    Mark
  4. Replies
    16
    Views
    7,608

    Your welcome. I changed my code around a little...

    Your welcome. I changed my code around a little as I needed to restrict my data to two byte integers.

    I am now using:
    uint16_t CLT, RPM, MAP, MAT, BATTV, TPS, GSI1, GSI2;

    switch (rxmsg.id)
    ...
  5. Replies
    16
    Views
    7,608

    Glad your headed in the right direction now. I...

    Glad your headed in the right direction now. I started the engine A OK. It was a problem with throttle linkage that was connected to an automatic governor. Now I will see if I can get some more...
  6. Replies
    16
    Views
    7,608

    I was typing fast on my reply last night as my...

    I was typing fast on my reply last night as my laptop battery was dying. I will be attempting other ID's today. Also I need to check TDC and reset the timing I think the firmware update threw off...
  7. Replies
    16
    Views
    7,608

    OK today I upgraded the firmware of my...

    OK today I upgraded the firmware of my MicroSquirt to 3.4.1 and turned on Dash Broadcasting. I added some code to an existing program that I am using on a Teensy3.1 and read coolant temperature from...
  8. Replies
    16
    Views
    7,608

    Give a me a couple days, I will give it a try. I...

    Give a me a couple days, I will give it a try. I have a microsquirt on a running engine. I currently have two teensy3.1s talking over can bus to each other. I will connect the microsquirt to the...
  9. Replies
    16
    Views
    7,608

    Let me ask you a few questions first. What...

    Let me ask you a few questions first. What Microsquirt Firmware Version are you running ? I assume you have broadcasting enabled in TunerStudio. What is the interval set to ?? What data do...
  10. Replies
    2
    Views
    945

    I see FastCRC uses the on-chip hardware for...

    I see FastCRC uses the on-chip hardware for Teensy 3.0 / 3.1
  11. Replies
    358
    Views
    185,682

    I wanted to post to thank everyone who worked on...

    I wanted to post to thank everyone who worked on getting the canbus drivers for the teensy3.1 completed. I am working on a project which uses two teensy3.1's working together to implement 4 wheel...
Results 1 to 11 of 12