Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: MO_YA_NE

Search: Search took 0.00 seconds.

  1. Replies
    27
    Views
    3,430

    I extended the harness length to 2.5m and...

    I extended the harness length to 2.5m and experimented again.
    I sent and received 20Mbps by 5000byte.

    The result was all 5000 bytes OK.
    It was carried out about 10 times, and the same result was...
  2. Replies
    27
    Views
    3,430

    I tried a program that connects teensy 4.1 and...

    I tried a program that connects teensy 4.1 and PIC32MZ and echo back.
    Teensy 4.1 sends characters at 20Mbps and PIC32MZ just adds 1 and returns.
    It looks working fine.


    void setup() {
    ...
  3. Replies
    27
    Views
    3,430

    I have not tried to send and receive actual data...

    I have not tried to send and receive actual data yet.
    I just saw the output waveform of TX1.
    I'm going to connect Teensy 4.1 with Renesas RX72T and Microchip PIC32MZ with RS485 and try the actual...
  4. Replies
    27
    Views
    3,430

    Thank you Mr. KurtE ! It was exactly what you...

    Thank you Mr. KurtE ! It was exactly what you said!
    I am very grateful for your advice.
    I succeeded in raising the baud rate to 20Mbps.

    I just rewrote the UART_CLK_SEL bit in the CCM_CSCDR1...
  5. Replies
    27
    Views
    3,430

    Thanks for your reply Kurt-san. I hope I can...

    Thanks for your reply Kurt-san.
    I hope I can get a higher baud rate with the method you suggested.

    I'm still not familiar with the clock division of the IMXRT1060.
    I'll try your ideas as I...
  6. Replies
    27
    Views
    3,430

    Teensy4.1 MAX baud rate

    Hi!
    I have been teensydiuno for the third day.
    I want to communicate with other MPUs at high speed using RS485 communication.
    I set the teensy 4.1 hardware serial to 6Mbps, but higher values...
Results 1 to 6 of 6