I just went with the driver recommended on the site at checkout. I don't believe sending a non-square wave will improve matters, since it is a digital stepper driver - I think it just monitors edges....
Type: Posts; User: esdraelon
I just went with the driver recommended on the site at checkout. I don't believe sending a non-square wave will improve matters, since it is a digital stepper driver - I think it just monitors edges....
OK, it appears to just be a bad driver. I turned it down to 1HZ, and I can see that it pulses in the HIGH direction, but not in the LOW direction.
Thank you for helping. I have ordered another...
It is a very tiny motor. It shows the same behavior at 10khz and 100hz.
I tried at 100hz with the same results.
OK, corrected.
23393
Sorry if this a repeat question. I spent a good portion of the last couple evenings trying to figure out what I'm doing wrong, searching thither and yon.
Virtually all of the hits on Google refer...