Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: f6duk

Search: Search took 0.00 seconds.

  1. Replies
    579
    Views
    103,600

    Almost everything looks ok now, could copy first...

    Almost everything looks ok now, could copy first signals, just looking for getting preselector switching to work
  2. Replies
    579
    Views
    103,600

    Dear Frank A little progress report, could fix...

    Dear Frank

    A little progress report, could fix the Encoder issue, When I plugged the T4 in the Audio board, 1 side from Enc2 was pulled to ground by Audio board , I cut these pins and it starts to...
  3. Replies
    579
    Views
    103,600

    I Commented some other...

    I Commented some other !defined(HARDWARE_DD4WH_T4) lines 10148 10214 12251 13631 they ar still some uncommented ones but and do not clearly understand the consequence. But now I have audio. Still...
  4. Replies
    579
    Views
    103,600

    Hi Frank Of course no audio and that could be...

    Hi Frank

    Of course no audio and that could be a serous reason thanks or the clue will try it and keep you informed.
  5. Replies
    579
    Views
    103,600

    Last news: encoders work, I changed encoderbounce...

    Last news: encoders work, I changed encoderbounce against encoder we come closer...
  6. Replies
    579
    Views
    103,600

    Dear Frank Some new facts Problem seems not to...

    Dear Frank
    Some new facts
    Problem seems not to be where I thought. If I decrease sample rate I get the correct frequencies but the only pulse encoder that works correctly is the frequency encoder....
  7. Replies
    579
    Views
    103,600

    Dear Frank thank you for your patience you may...

    Dear Frank thank you for your patience you may wonder that I am not (yet) an expert but I feel that time has come to do something else than tayloring crystal filters!

    I start from the previous...
  8. I think you could be right just could not find...

    I think you could be right just could not find where this is located
  9. I think that 45Mhz is ways to much as MCLK for...

    I think that 45Mhz is ways to much as MCLK for the SGL5000, I hvae the requested 11Mhz during booting ut then goes to 45 Mhz and of course it doesn't work.
  10. Help needed Teensy Convolution SDR T4 and Audio Board Rev D

    Dear all
    I need help! I could compile the software menus are working as they should frontend is OK wit correct frequencies. But I am stuck with linking the T4.0 and audio board SGTL5000 rev D ...
  11. Replies
    579
    Views
    103,600

    Dear all, As amn old analog guy I took the...

    Dear all, As amn old analog guy I took the opportunity to go on this project. I use a Teensy4 did uncomment #define HARDWARE_DD4WH_T4
    could compile Software and frontend are OK but cannot igure out...
Results 1 to 11 of 13