Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: waltsatan

Search: Search took 0.00 seconds.

  1. Ugh, never mind. I just realized I had a Teensy...

    Ugh, never mind. I just realized I had a Teensy in my PCB that didn't have a pin 13 soldered to connect to the header. Hooray for stupid fixes!
  2. Wiz820io and Teensy 3.2 with different CS and RESET pins

    Hi all,

    I'm getting a 0.0.0.0 IP address from Ethernet.localIP() and EthernetNoHardware from Ethernet.hardwareStatus() after moving the reset and chip select pins connecting a Wiznet 820io to a...
  3. You need to use dac1.analogReference(EXTERNAL);

    You need to use dac1.analogReference(EXTERNAL);
  4. Thanks, Gibbedy. I ordered some various LEDs...

    Thanks, Gibbedy. I ordered some various LEDs today and will prototype next week. I'll report back with some results.

    Alan
  5. Teensy 3.2 + FastLED + WS2811_PORTD + Different lengths of LEDs

    Hi all,

    I'm looking to control 5 separate WS2811 strips of different lengths with parallel output to maximize performance. Is this possible? Pins 2, 5, 6, 7, 8, 14, 20, 21 on a Teensy 3.2...
  6. 1200 WS2801s + Teensy 3.6 + 2 SPI channels

    Hi all,

    I'm developing a project with 1,200 WS2801 LEDs and a Teensy 3.6. I'll be using FastLED to control them. Will I see any performance improvement if I put 600 LEDs on SPI0 and the other...
  7. Replies
    3
    Views
    1,380

    Netflix "Maniac" GRTA Mainframe

    Hi all,

    Last fall I built and programmed the mainframe in Netflix's Maniac series using a Teensy 3.2 as the real "mainframe". It was a wild project done in less than 5 weeks. I'd like to thank...
  8. Replies
    0
    Views
    199

    TPIC6B596N + Teensy 3.2

    Hi all,

    I'm swapping a Teensy into a project that previously used an Arduino Uno. One of its functions was to control 32 20mA LEDs using 4 TPIC6B596N...
Results 1 to 8 of 8