Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: Rotario

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    175

    Hi Len, There's no need to put the unlock...

    Hi Len,
    There's no need to put the unlock sequence, as the startup early hook runs inside the WCT (Watchdog config time) at startup, I've added it anyway, and no change! I think your solution would...
  2. Replies
    4
    Views
    175

    Teensy 3.6 watchdog Timer ISR not firing

    Hi,

    I've set up the watchdog using startup_early_hook and enabled the ISR with NVIC_ENABLE)_IRQ but the isr still isn't firing, I'm using a teensy 3.6.

    There's another thread here...
  3. Thanks for the reply, I've been away for a week...

    Thanks for the reply,
    I've been away for a week so not able to test anything, I'm afraid I don't understand much arm-specific code so this may be a stupid question, but does PORTA refer to 8...
  4. Ok, so if I set the mainline code priority...

    Ok,
    so if I set the mainline code priority higher or both the ISRs to 192 priority, then they won't fire?
    Is there a function in Teensyduino to set these interrupt priority numbers?
    I noticed...
  5. noInterrupts() allowing some interrupts - LIS3DH, NRF24L01+, Teensy 3.6

    Hi,
    I've got a rather complex project using both LIS3DH and NRF24L1+ with the Teensy 3.6 with two interrupt pins for the chips respectively.
    the accelerometer(LIS3DH) is being read at around 1.6kHz...
Results 1 to 5 of 5