Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: esdraelon

Search: Search took 0.00 seconds.

  1. I just went with the driver recommended on the...

    I just went with the driver recommended on the site at checkout. I don't believe sending a non-square wave will improve matters, since it is a digital stepper driver - I think it just monitors edges....
  2. OK, it appears to just be a bad driver. I turned...

    OK, it appears to just be a bad driver. I turned it down to 1HZ, and I can see that it pulses in the HIGH direction, but not in the LOW direction.

    Thank you for helping. I have ordered another...
  3. It is a very tiny motor. It shows the same...

    It is a very tiny motor. It shows the same behavior at 10khz and 100hz.
  4. I tried at 100hz with the same results.

    I tried at 100hz with the same results.
  5. OK, corrected. 23393

    OK, corrected.

    23393
  6. Stepper Won't Reverse, Instead Cooks Eggs

    Sorry if this a repeat question. I spent a good portion of the last couple evenings trying to figure out what I'm doing wrong, searching thither and yon.

    Virtually all of the hits on Google refer...
Results 1 to 6 of 6