Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: Chris314

Search: Search took 0.00 seconds.

  1. Maybe you could set the payload length to the...

    Maybe you could set the payload length to the minimum required for your data? don't know if it helps much, but maybe a little
  2. What do you need those many transactions per...

    What do you need those many transactions per second for? Maybe you can buffer some data and send it in packages? For my particular setup and code the minimum distance between two radio.write() was...
  3. Hey Phil, finally had success transferring audio...

    Hey Phil, finally had success transferring audio and data at the same time. I simply changed the SPI clock divider in the RF 24 Library (rf24.cpp) to a somewhat lower value.
    Furthermore i found out...
  4. Hey Phil, thanks for the idea! Gonna try to...

    Hey Phil,

    thanks for the idea! Gonna try to make it work with the tips you wrote!

    Greetings
    Chris
  5. Code just slightly too slow to wirelessly stream audio via Nrf24L01+?

    Hello,

    I tried to make a wireless live mono audio link with a Teensy 3.2 as a transmitter and Teensy 4.0 as a receiver.
    Mainly copied a code example I found somewhere in the forum and changed it...
  6. Replies
    5
    Views
    196

    Thank you very much, Paul! Selecting mode 1 seems...

    Thank you very much, Paul! Selecting mode 1 seems to do the trick - think the board had the chip in mode 3 by default. Because I couldn't figure out how the CKS-pin was connectet to VCC on the PCB, I...
  7. Replies
    5
    Views
    196

    Strangely, when I connect the ADC Module at the...

    Strangely, when I connect the ADC Module at the same time with a Teensy audio shield, it works as it should like I just found out..
  8. Replies
    5
    Views
    196

    Hey Paul, thanks for the reply! As far as...

    Hey Paul,

    thanks for the reply!

    As far as I understand, this particular chip needs a ratio of 32fs to output 16 bit data. At least that's written in the datasheet on page 16, last row: "Note...
  9. Replies
    5
    Views
    196

    I2S: How to set the BCLK to LRCLK ratio?

    Hello,

    I just bought myself a ADC board with a AK5720 chip, using it to input audio into the Teensy 4.0 via I2S. In the datasheet it says one has to insert a clock ratio of BLCK/LRCLK=32fs to get...
Results 1 to 9 of 9