Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: sozkan

Search: Search took 0.00 seconds.

  1. I believe, Sor of wiring error! Learning curve. I...

    I believe, Sor of wiring error! Learning curve. I think, the board in default low, and pnp transistor triggered in low signal and there was no protection! So it sucked 5 volt from emiter to base,...
  2. Thank you very much. I will try to understand....

    Thank you very much. I will try to understand. Teensy 3.6 not working now. It is heating where I have marked with red on the uploaded picture. 20562
  3. As I was running NPN transistor was no problem...

    As I was running NPN transistor was no problem with Teensy 3.6. I have connected Teensy 3.6 on Full Bridge drive. as soon as I have connected to PNP transistor, Board failed to disconnect. I have...
  4. Replies
    1
    Views
    102

    20187 Hi, I have solved the sensitivity issue...

    20187

    Hi,
    I have solved the sensitivity issue with using these simple filter circuit with 4 piece 10 k resistor without capacitor.
    Best
    Serkan
  5. Replies
    1
    Views
    102

    Teensy 3.6 Encoder Pin sensitivity issue.

    Hello,
    I have programmed Teensy 3.6 for driving stepper drives using hand wheels encoder.
    But It was worked a while. Pin sensitivity or noise issue making the trouble.
    After sometimes it start...
Results 1 to 5 of 5