Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: Kavyashree

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    982

    Hi, Did you use any pre amplification stage when...

    Hi,
    Did you use any pre amplification stage when you connected SPW2430 to line in pins?
  2. Replies
    34
    Views
    10,006

    Hi, In your circuit you have directly...

    Hi,

    In your circuit you have directly connected the mic to the line in pins. I wanted to know if there is a requirement of pre-amplification stage for that or connecting the mic to line in...
  3. Hi, I wanted to know if the kicad files...

    Hi,

    I wanted to know if the kicad files (footprint) for audio board are available
  4. Replies
    4
    Views
    862

    Teensy 3.6 is connected to laptop through usb....

    Teensy 3.6 is connected to laptop through usb. Part_1_02_Hardware_Test from the Audio examples of Teensyduino outputs continuous beeping sound, which was working earlier. Yes, audio headphones are...
  5. Replies
    4
    Views
    862

    Teensy 3.6 and audio board

    Hello,

    I am using Teensy 3.6 and audio board. I am trying to run the Hardware testing program from the example programs.
    I am able to get the values at the serial monitor but I am not able to...
  6. Replies
    16
    Views
    1,742

    No I did not connect Li Po to 3.3V pin.I...

    No I did not connect Li Po to 3.3V pin.I connected it to Vin( 3.6-5V).
    Yes, the teensy is getting hot.
  7. Replies
    16
    Views
    1,742

    Hello, I am using 3.7 V Li Po battery to power...

    Hello,

    I am using 3.7 V Li Po battery to power teensy 3.6 which is connected to audio board.
    I am able to get the same voltage at Vin Pin but the voltage reading at 3.3 V pin on teensy 3.6 is 0V....
  8. Connecting Audio board to Li Po battery charger

    Hello,

    I need to connect the Li Po battery charger to teensy audio board. What are the necessary connections?


    Thank you
  9. Replies
    5
    Views
    712

    Hi I tried using digitalRead() and I was able...

    Hi

    I tried using digitalRead() and I was able to switch the inputs, ut there is a lot of noise. I will try using bounce library.
  10. Replies
    5
    Views
    712

    Hi, Can I use commands to setup multiple...

    Hi,

    Can I use commands to setup multiple inputs for the sgtl5000?
    Eg : int a= AUDIO_INPUT_MIC;
    int b= AUDIO_INPUT_LINEIN;
    void setup()
    {
    sgtl5000_1.inputSelect(a);
    ...
  11. Replies
    5
    Views
    712

    Switch Inputs

    Hello,

    I want to switch inputs to the teensy audio board from mic in to line in using slide switch.
    What are the libraries that I need to add to do so?



    Thank you
Results 1 to 11 of 11