Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: benkrasnow

Search: Search took 0.00 seconds.

  1. Thanks again. Yes, I agree that I have too many...

    Thanks again. Yes, I agree that I have too many __disable_irq()'s I think I originally had these before changing the ADC irq priority to be 8. The program has no known glitches when it is running...
  2. Thanks for all of the suggestions. The plot of...

    Thanks for all of the suggestions. The plot of input voltage to ADC counts looks like this (photo attached) when it is in the failed condition. The voltage waveform being supplied is a clean...
  3. Thanks for your quick suggestion -- I was not...

    Thanks for your quick suggestion -- I was not aware of INPUT_DISABLE. It seemed to have no effect in this case, though. I should add that the above code works perfectly fine for a week, then fails...
  4. Permanent ADC damage caused by running this code

    I take a brand new Teensy 3.6 out of the package, and connect it to the computer with a short USB cable, and attach one of the analog pins and digital ground to a benchtop signal generator (photo). ...
  5. Replies
    2
    Views
    649

    XBAR setup on T4

    Hi all. I'm really excited about using the T4 in a big upcoming project, but am getting off to a rocky start. The XBAR can route PWM and/or GPIO into DMA triggers, which is exactly what I need. ...
  6. I may have found a partial solution: Replace the...

    I may have found a partial solution: Replace the SD.h library with SdFs. The following code has been working well with many fewer glitches, but I have not tested extensively. I renamed the object...
  7. Audio samples lost due to SD card writes

    This simple audio recorder code takes I2S input from the Teensy audio shield, and saves a mono channel continuously to SD card. I'm feeding the line-in input on the shield with a 40Hz triangle wave...
Results 1 to 7 of 7