Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: timseverance77

Search: Search took 0.00 seconds.

  1. Love it! Thanks... Tim

    Love it! Thanks...
    Tim
  2. Thank you so much for the confirmation. I was...

    Thank you so much for the confirmation. I was racking my brain trying to figure out why the oscillator wouldn't work.
    Do you happen to know if the USB connection would register anything in...
  3. Teensy 3.2 custom hardware empty MKL02

    Hi,
    I am working with custom hardware that I designed using the Teensy 3.2 schematic with the MK20DX256VLH7 and the MKL02Z32VFG4 and I am thinking that the purchasing department accidentally...
  4. Dumb me. Sorry, it was a pullup on the hardware...

    Dumb me. Sorry, it was a pullup on the hardware (non-teensy). We can disregard this whole thread. Thanks for your time!
    Tim
  5. Is there a low level command where I can readback...

    Is there a low level command where I can readback the MUX settings for that pin? And is there a datasheet page you would recommend looking at for the uC?
    Thanks
  6. Thanks. That is good advice, I made a dummy...

    Thanks. That is good advice, I made a dummy sketch where the only command is to do an analogRead on pin 37 and it is still acting like there is a pullup.
    Here is the circuit:
    1.481V source --> 1k...
  7. Thanks for the quick reply. I tried that, I do...

    Thanks for the quick reply.
    I tried that, I do not do any pinMode settings at all, then do an analogRead on the pin and it is still pullup up the voltage I want to measure.
    As a side note, I...
  8. Teensy 3.6 pins 37/38 can't seem to disable pullups

    I am using a Teensy 3.6 with I2C enabled for pins 18/19 which makes sense to have pullups, but I can't seem to disable the pullups on pins 37/38 (A18_PWM_SCL1/A19_PWM_SDA1).
    I know there are pullups...
Results 1 to 8 of 8