Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: 3D Joy

Search: Search took 0.00 seconds.

  1. Replies
    501
    Views
    189,422

    Sorry to derail too much. Yeah they work at...

    Sorry to derail too much.

    Yeah they work at 3.3V here too but not after 24'' of 144/m APA102. I'd like to get more than double that and I know I can use the level shifters mentioned everywhere...
  2. Replies
    501
    Views
    189,422

    Well Paul if you don't fully understand something...

    Well Paul if you don't fully understand something I'm really out of this loop.
    Thanks for all that are participating in the developpement of the prop shield.

    Seriously all I need to do is make...
  3. Replies
    8
    Views
    2,277

    I am very impressed.

    I am very impressed.
  4. Thread: LED Statue

    by 3D Joy
    Replies
    65
    Views
    15,722

    Get a gas powered soldering iron? A small...

    Get a gas powered soldering iron? A small generator?
  5. Not to go too much out of line with the thread...

    Not to go too much out of line with the thread but may I ask if these would work fine for Teensy 3.1 and APA102C LEDs ?
  6. Replies
    27
    Views
    15,831

    Excuse my ignorance if its very obvious to others...

    Excuse my ignorance if its very obvious to others but arent the Teensy's outputs at 3.3V and these LEDs need 5V signals to work properly?
    It is my understanding that you would need something like...
  7. Replies
    4
    Views
    1,481

    OK thanks alot. I did the cut, removed the 8...

    OK thanks alot.

    I did the cut, removed the 8 ground pins completely and then soldered 8 new signal wires that go to 8 radio controlled type plugs. These have 3 wires (pos, neg and signal) so they...
  8. Replies
    4
    Views
    1,481

    Can I remove the RJ45 plugs from OctoWS2811

    I would like to cut off the RJ45 connectors and simply solder the signal wires directly to the OctoWS2811. Ground and positive wires will be all soldered together to an appropriate power supply.
    Am...
  9. Replies
    1
    Views
    1,313

    If that matters, all the LED strips I ordered are...

    If that matters, all the LED strips I ordered are 60 pixels/m 5050 leds.
  10. Replies
    1
    Views
    1,313

    Persistence of vision in an RC plane

    Alright, I somehow got myself into POV.
    The RC plane part is very easy for me, been doing that for 20 years.
    The POV and the microcontrollers are all new to me though but I've done quite a bit of...
Results 1 to 10 of 10