Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: dani190

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    3,898

    Thanks Paul, that worked and i just modified my...

    Thanks Paul, that worked and i just modified my code a bit further. By adding a delay to the actual start of the code that allowed the LCD to start fully and then start the code.

    My code now looks...
  2. Replies
    7
    Views
    3,898

    My exact setup has an LCD connected to the TX pin...

    My exact setup has an LCD connected to the TX pin and it turns on at the same time with the Teensy 2.0 using the same power supply.

    Any ideas what could be wrong?
  3. Replies
    7
    Views
    3,898

    The code on my teensy 2.0 is as follows ...

    The code on my teensy 2.0 is as follows




    As for tools > USB Type is set as serial
  4. Replies
    7
    Views
    3,898

    teensy 2.0 and teensy 3.0 question

    Hello, was wondering is there any way to make the Teensy load the code it has on it upon boot?

    I find that when i turn the power on my script does not run. I know this because my LCD's are not...
  5. Replies
    2
    Views
    2,436

    Teensy 2.0 Real Time clock

    Is there anyway to get the Teensy 2.0 to keep time? With the Teensy 3.0 there is the ability to put a crystal and a backup battery. Can this be done with Teensy 2.0?
  6. Replies
    4
    Views
    5,000

    Thanks Paul, shortly after I posted I found the...

    Thanks Paul, shortly after I posted I found the info I needed in the Arduino docs.
  7. Replies
    4
    Views
    5,000

    Paul, how would you go about initializing them...

    Paul, how would you go about initializing them then?

    Is there an doc's on this sort of thing to look it up?
Results 1 to 7 of 7