Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: lkiss10

Search: Search took 0.00 seconds.

  1. Replies
    420
    Views
    34,753

    I have got the answer from the support, I can...

    I have got the answer from the support, I can remove the 120 ohm resistance. I hope it will work. It would be very simple to make a jumper or dip-switch for this function.
  2. Replies
    420
    Views
    34,753

    Ah, you are right. It must be a connector. I...

    Ah, you are right. It must be a connector.
    I have sent the question to the Waveshare support.
  3. Replies
    420
    Views
    34,753

    Hello, Can anybody help me to understand, how...

    Hello,

    Can anybody help me to understand, how to use the Waveshare can transceiver SN65HVD230 chip? I want to close the canbus ends with 2pcs separated 120 ohm resistor, so I dont need resistor on...
  4. Replies
    420
    Views
    34,753

    Hi tonton81, You were right, finally I have...

    Hi tonton81,

    You were right, finally I have read through the Flexcan part of the IMXRT1062 manual, and it helped a lot to understand the process.
    https://www.pjrc.com/teensy/IMXRT1060RM_rev2.pdf...
  5. Replies
    420
    Views
    34,753

    Ok, I see. How can I read always the last message...

    Ok, I see. How can I read always the last message with the same ID and remove the older not read messages?
    I plan to use canbus for RC servo control. The main Teensy sends data in every 0.01s to...
  6. Replies
    420
    Views
    34,753

    Hello tonton81, Thanks for your suggestion. I...

    Hello tonton81,

    Thanks for your suggestion. I am reading them through.
    No, I am not a programmer, so I dont need the very deep water(registers, clocks), just would like to understand basic things...
  7. Replies
    420
    Views
    34,753

    Hello, I am new in the CAN BUS world. Can you...

    Hello,

    I am new in the CAN BUS world. Can you propose any document, what explains how FlexCAN work. I have read a lot of threads, but it is difficult to put all puzzles together. I could find...
Results 1 to 7 of 7