Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: tecnico.solarboat

Search: Search took 0.00 seconds.

  1. Good point you have there. I didn't thought of...

    Good point you have there. I didn't thought of that because I have only one device on the bus. That should be the reason why SPI.begin() does not take care of the configurations.
  2. I didn't though of that. I will give it a try...

    I didn't though of that. I will give it a try when I'm near the board. Afterwards I will post the result.

    Nonetheless I think this should be considered as a bug. SPI.begin() should put the bus in...
  3. The problem is that SPI.setDataMode is deprecated...

    The problem is that SPI.setDataMode is deprecated by Arduino see https://www.arduino.cc/en/Reference/SPISetDataMode and this behaviour causes the slave (LTC 68111) to ignore the first message because...
  4. SPI.begin() does not set Clock HIGH in SPI_MODE3

    If SPI settings are set to SPI_MODE3 clock signal should idle at HIGH but before doing:



    SPI.beginTransaction(LTC6811_SPI_config);


    and after doing SPI.begin(); being
Results 1 to 4 of 4