Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: manitou

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    5,098

    well, there is a small chance you have modified...

    well, there is a small chance you have modified the sketch such that buttons aren't config'd/tested? maybe, load a fresh copy of the tutorial sketch.
    you can run jumpers from GND to A1 A2 and A3 to...
  2. Replies
    12
    Views
    5,098

    if the buttons aren't working, do as defragster...

    if the buttons aren't working, do as defragster suggested: pull the button off the breadboard and rotate it 90 degrees

    and yes, the 3rd image is different from all others. the GND pin is top pin...
  3. Replies
    12
    Views
    5,098

    a bit hard to trace the wires from the photo. ...

    a bit hard to trace the wires from the photo. the sketch prints A1,A2,A3 values only when they change by 50, and you only have 2 pots hooked, so A1 (i think) is floating, and its value will be...
Results 1 to 3 of 3