Search:

Hi Gibbedy,

After a busy period finishing the art installations I wanted to let you know that thanks to your suggestions I solved my issue with frying my Teensy's. At the end I connected the...

Sounds like a plan. A few questions left. Do I need to connect the ground of each power supply? Currently i am using two identical 12A power supplies which I haven’t connected through ground so far. ...

Hi Gibbedy, thanks for your help so far. The strange thing is that it occurs with other identical power supplies as well. I have four of these and previous Teensy’s died also on one of the other...

25234

25235

25236

25237

25238

as requested :)

25228
25229
25230
25231

please ask if other photos are required. The LED strips are made in China, somehow the + and - are switched :)).

Hi Maxwell,

I am looking for ways to power my teensy 3.2 with an octoboard safely. What was your result using these regulators and can you tell me what regulator works best?

Best, Rob

Hey guys,

I am back on this issue after some time. I have had a lot of difficulties with external power on the Teensy 3.2 and I have lost already 5 of them, each with an Octo board. Everything...

Hi Paul,

Thanks for your reply. I checked the power on the 3.3v pin according to Gibbedy's request. Why is the teensy not powered by the Octoboard? I get 0V when I check the GND and Vin pins on...

See attachment for my set up.

I get 4v from the 3.3v pin (the pin in between GND and VBat)

Without this my Teensy board dus not power up and does not receive power from the Octoboard. I cut the...

Hi guys,

For a permanent light art installation I am using Teensy 3.2 and 6 60led led strips.

I have a teensy 3.2 with an octo board soldered on it. I have cut the connection for usb power, so...