Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: sniper1rfa

Search: Search took 0.00 seconds.

  1. Sorry, I should have been more clear. I have...

    Sorry, I should have been more clear.

    I have a machine whose controller is expecting a VR sensor as a tachometer. A hardware change means that the new sensor hardware is hall effect, so i need to...
  2. simulating a variable reluctance sensor...

    Long story short, I am in a position where I need to intercept a ~100 line hall effect magnetic encoder, and scale it to a ~40 line VR sensor. I'd like to get some advice on the best way to proceed. ...
  3. Replies
    6
    Views
    1,136

    OK, sounds good. I'll keep an eye on it. I...

    OK, sounds good.

    I'll keep an eye on it. I think the high voltage I read previously was a measurement error - the regulator seems to be stable at the correct voltage now.

    Thanks!
  4. Replies
    6
    Views
    1,136

    Thanks guys. I dropped a pair of 0.1uF caps...

    Thanks guys.

    I dropped a pair of 0.1uF caps in, and that brought it down to 15 counts. It should work even at 20 - the pot position is being run through an integrator so the noise should get...
  5. Replies
    6
    Views
    1,136

    Teensy 3.1 analog help

    I've got a couple questions about analog inputs with the teensy.

    I'm using a 10kohm potentiometer (BI tech P270, linear taper, polymer element) to measure the absolute position of a shaft. I'm...
Results 1 to 5 of 5