Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: Constantin

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    7,479

    Well, FWIW, even if I set the...

    Well, FWIW, even if I set the analogWriteResolution to 8 and use 128 for AnalogWrite, I get nothing in setup now. I have no idea why and it doesn't really matter. I'll simply set it up once in loop...
  2. Replies
    10
    Views
    7,479

    Apologies! Just goes to show how I...

    Apologies!

    Just goes to show how I misunderstood the documentation. I will heed your advice. For whatever reason, I thought that the number in the analogWriteResolution command referred to the...
  3. Replies
    10
    Views
    7,479

    Reproduced the problem...

    Hi Paul,

    Thank you for your kind offer. Below is my code to date. FWIW, there is no SQW output during setup at all now. Only if I enable it in loop(). Perhaps my single bit resolution setup is...
  4. Replies
    10
    Views
    7,479

    Weird. When I tried it on my Teensy 3, the...

    Weird.

    When I tried it on my Teensy 3, the PWMs on pin 6 only happened during the setup phase, then stopped when the MCU started executing the loop (). This is per my Saleae logic 8. Maybe Mr....
  5. Replies
    10
    Views
    7,479

    A couple of observations from the trenches... ...

    A couple of observations from the trenches...

    So I tried enabling the PWM on Pin 6 in the setup() function and expected it to carry over as implied above. Not so. PWM started in the setup()...
  6. Replies
    10
    Views
    7,479

    Hi Paul, Thank you so much for the response, I...

    Hi Paul,

    Thank you so much for the response, I will try it out, as my board is already borked to bits. However, my max input frequency is 16MHz, which I gather I cannot attain due to there not...
  7. Replies
    10
    Views
    7,479

    Question re: analogWriteFrequency command

    Hi,

    If I invoke the analogWriteFrequency command on a Teensy 3.0, does the affected pin just keep cycling ad infinitum until it's told to stop? (I presume so)

    Does this cycling consume any...
Results 1 to 7 of 7