Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: tonton81

Search: Search took 0.01 seconds.

  1. if it has it then no, you can verify the...

    if it has it then no, you can verify the resistance of the line with a multimeter on CANH and CANL, it should show about 60 ohms if both sides have 120 ohm resistors
  2. should be a 120 ohm resistor on CANH accross CANL...

    should be a 120 ohm resistor on CANH accross CANL at both furthest ends of the bus. if you have only 2 devices then put 120 ohm resistor at the sensor side and one at teensy side:

    CANH <--> 120...
  3. you checked your line terminations? i assume the...

    you checked your line terminations? i assume the sensor doesnt have one?

    i can connect a car sensor directly to t4 and it works at 125kbps as well, doesn't mean the higher speeds will work :)
  4. you need to use setClock(CLK_60MHz); also make...

    you need to use setClock(CLK_60MHz);

    also make sure your line terminations on CAN are correct or it may not work at all speeds
  5. 1000 does work, maybe the clock timings are...

    1000 does work, maybe the clock timings are different for your application (device your connected to), try changing the clock? can.setClock(clock speed) then run setBaudRate again, default is 24, you...
Results 1 to 5 of 5