Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: a.hinsen

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    176

    Hi Paul! I trusted teensy has a solution:) I feel...

    Hi Paul! I trusted teensy has a solution:) I feel sorry for not checking documentation enough thoroughly, because I believe in the concept of documentation in a world that is dumped with poorly...
  2. Replies
    6
    Views
    176

    Sounds promising! Any idea what to #include in...

    Sounds promising! Any idea what to #include in order to have usb_cdc_line_rtsdtr defined? (I couldn't find it in any installed lib)
  3. Replies
    6
    Views
    176

    Thank you Michael, but I am afraid there is a...

    Thank you Michael, but I am afraid there is a misunderstanding:
    You are talking about the flow control for SerialX (X=1,2,3...6) that is happening on the pins
    My question refers to Serial that is...
  4. Replies
    6
    Views
    176

    Flow control on USB Serial

    Dear Guys!
    ESP8266 based boards having USB port can be switched to programming mode, and back by the arduino IDE automatically. This is accomplished by a ch340 chip on the boaerd, that converts the...
  5. I have the same issue: programming Teensy 3.2s on...

    I have the same issue: programming Teensy 3.2s on the field (connected over CAN bus) without having to walk/climb etc. to each of them. OK, I understand, programming over the CAN bus is not a...
  6. Ooh yes, I messed up the baudrates, you are...

    Ooh yes, I messed up the baudrates, you are right. Now it works fine using either baud rate, as long as the same is used on both sides :)
    Thank you Erikk!
    Which FlexCAN function would I use to set...
  7. HelloWorld CAN bus with 2 Teensy3.1-s using FlexCAN

    Hi,
    I built a basic "Hello world" example to try the CAN functionality using 2 teensy3.1s and 2 MCP2551 CAN drivers:
    Transmitter teensy (USB connected to PC): On the click of the button, a 1 byte...
  8. Replies
    673
    Views
    377,035

    Cross wired! Yesss! Dang, I forgot to check that...

    Cross wired! Yesss! Dang, I forgot to check that earlier (I measured everything else in terms of connectivity and shortcuts...) Thank you, now it works!
  9. Replies
    673
    Views
    377,035

    No, I don't have external resistors. I activated...

    No, I don't have external resistors. I activated the internal ones in Wire.begin, and I could also see on the scope that they are actively pulled high. I can give it a try, though I don't expect...
  10. Replies
    673
    Views
    377,035

    Hi All, My first project with my new Teensy 3.1...

    Hi All,
    My first project with my new Teensy 3.1 is to use I2C to read a temperature sensor. I constructed the code below based on the examples, and using the library provided by nox771 (thank you!)....
Results 1 to 10 of 10