Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: BenJo

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    209

    Thank you very much for this detailed...

    Thank you very much for this detailed explanation!
    Best Regards!
  2. Replies
    10
    Views
    209

    I add the I2S output an now it works. Thank you...

    I add the I2S output an now it works. Thank you so much!
    Just for better understanding: is there any technical reason, why many example sketches don't has this I2S already prepared? If I'm using a...
  3. Replies
    10
    Views
    209

    Thank you! Just to be sure that I understand it...

    Thank you!
    Just to be sure that I understand it correctly:
    -> If I plug any I2S-device to the T4, the audio libary will probaply work. (audio shield for example)
    -> And if I wait for the next...
  4. Replies
    10
    Views
    209

    Thank you for your answers! The latest 1.54...

    Thank you for your answers!
    The latest 1.54 beta7 is installed.
    What i did not mind yesterday, this massage appears while compiling:

    C:\Program Files...
  5. Replies
    10
    Views
    209

    Teensy 4.1 A2 input question

    Hi Folks,

    yesterday I received my first Teensy4.1 (after using ++2.0 for long time) and i was very excited to try out the audio libary. In the end, I was very frustrated and now I hope you can...
  6. Replies
    5
    Views
    437

    Thats absolutely right, but the input Pin 17 is...

    Thats absolutely right, but the input Pin 17 is hard on VCC+5 volts and if i use a capacitor and resistors to pull it down, it ends in crazy distortion.
    Left picture is the signal directly from 5 V...
  7. Replies
    5
    Views
    437

    FreqMeasure Libary Measure Voltage

    Hello Board,

    I have a question about the standard FreqMeasure Libary on a Teensy ++2.0 and I hope somebody can help!

    On the input Pin 17, I have a rectangular curve between p-p +2V and +5V and...
  8. Replies
    4
    Views
    389

    This libary works very accurate, I can say it`s...

    This libary works very accurate, I can say it`s around only +/- 0,01 Hz deviation!
    Do you see any chance to combine this libary with my program? Because normally I need a analog (ADC) input with...
  9. Replies
    4
    Views
    389

    Understand, thanks a lot! Is there a chance to...

    Understand, thanks a lot!
    Is there a chance to become more accurate by software optimization or is it a hardware limitation?
  10. Replies
    4
    Views
    389

    Frequency meter, inaccurate at Teensy ++2.0

    Hello Board,

    hope you can help!

    I try to build up an frequency meter but I have problems to reach the needed accuracy.
    Whats important to me:
    -Frequency range from 50Hz to 500 Hz
    -Accuracy...
  11. Replies
    0
    Views
    192

    RX (D2) why oscillating?

    Hey Folks,

    I'm using the ++2.0 in an audio project and everything runs how it should. There is only one problem: the RX Pin (D2/2) is oscillating with a frequency of 2203 Hz or 2344 Hz and this...
Results 1 to 11 of 11