Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: sniper1rfa

Search: Search took 0.00 seconds.

  1. Following up to close this out, for the benefit...

    Following up to close this out, for the benefit of those traveling through time on the ol' web search buggy.

    The purpose of this is to allow the use of modern bolt-in wheel bearings on an older...
  2. Sorry, I should have been more clear. I have...

    Sorry, I should have been more clear.

    I have a machine whose controller is expecting a VR sensor as a tachometer. A hardware change means that the new sensor hardware is hall effect, so i need to...
  3. simulating a variable reluctance sensor...

    Long story short, I am in a position where I need to intercept a ~100 line hall effect magnetic encoder, and scale it to a ~40 line VR sensor. I'd like to get some advice on the best way to proceed. ...
  4. Replies
    6
    Views
    1,149

    OK, sounds good. I'll keep an eye on it. I...

    OK, sounds good.

    I'll keep an eye on it. I think the high voltage I read previously was a measurement error - the regulator seems to be stable at the correct voltage now.

    Thanks!
  5. Replies
    6
    Views
    1,149

    Thanks guys. I dropped a pair of 0.1uF caps...

    Thanks guys.

    I dropped a pair of 0.1uF caps in, and that brought it down to 15 counts. It should work even at 20 - the pot position is being run through an integrator so the noise should get...
  6. Replies
    6
    Views
    1,149

    Teensy 3.1 analog help

    I've got a couple questions about analog inputs with the teensy.

    I'm using a 10kohm potentiometer (BI tech P270, linear taper, polymer element) to measure the absolute position of a shaft. I'm...
Results 1 to 6 of 6