Forum Rule: Always post complete source code & details to reproduce any issue!

Search:

Type: Posts; User: KurtE

Search: Search took 0.01 seconds.

  1. Replies
    21
    Views
    400

    @PaulStoffregen - I put in PR:...

    @PaulStoffregen - I put in PR: https://github.com/PaulStoffregen/Wire/pull/16

    Not sure if this is the best solution or not, but???
  2. Replies
    21
    Views
    400

    @PaullStoffregen @mjs513 ... I used a few...

    @PaullStoffregen @mjs513 ...

    I used a few sledge hammers and I got it to not stick... But not sure if correct to do?

    The main thing is I clear out FIFO queue and clear FTF

    Here are the two...
  3. Replies
    21
    Views
    400

    @... I also updated the code to print out...

    @...

    I also updated the code to print out everything (like @mjs513 did earlier) plus add a printf at start of endTransmission and requestFrom to get ideas of what is going on...

    ...
  4. Replies
    21
    Views
    400

    @mjs513 @PaulStoffregen - I think one hint is...

    @mjs513 @PaulStoffregen - I think one hint is what you printed out:

    status timeout = 1000

    At first I thought the 1000 was simply the timeout value, then saw that it is the value from the MSR
    ...
  5. Replies
    21
    Views
    400

    @mjs513 - Good morning, I decided to instrument...

    @mjs513 - Good morning, I decided to instrument the code as well with digitalWriteFast calls. I knew that the BNO055 code was hanging after the reset was sent, and it did one query and got a NAK......
  6. Replies
    21
    Views
    400

    I did a quick look at running the same sketch...

    I did a quick look at running the same sketch with a T3.0 (I thought I was grabbing a 3.2, but...)

    So ran it again and the with the Reset function in place, sure enough the next output Was Setup...
  7. Replies
    21
    Views
    400

    I also looked at it with Logic Analyzer and it...

    I also looked at it with Logic Analyzer and it outputs the reset command, which I did not notice anything unusual...

    Then it tried to output the next command, which it NAKEd once and that was the...
  8. Replies
    21
    Views
    400

    For the heck of it, went to my display and...

    For the heck of it, went to my display and sensors box and found an BNO055 and hooked up the same as Paul.

    Ran Wire example scanner:

    Scanning...
    Device found at address 0x28 ...
Results 1 to 8 of 8