Hi -
I'm new to Teensy, but I have some familiarity with programming and soldering. I apologize if I'm posting in the wrong thread - this is a little bit of a beginner question, a little bit of an audio question, and a little bit of a "guidance" question.
I'd like to make a stand-in for a "Control Surface" - they cost too much, it doesn't make sense to me why.
Searching around on the forum, I've noticed two things about this subject - first, posters tended to feel strongly about also producing the motorized faders and secondly, I'm finding myself a little uncertain about the protocol (do control surfaces just use MIDI?)
Considering these damn things are $500, I'm wondering what the best route to my DAW's sliders might be. My thinking is that I don't really need the motors, but it seems like it might be worthwhile to use a resolution higher than MIDI messaging, if left to my own human-interface devices. There are some major questions about
Can anyone help get me started down this path? Thank you.
I'm new to Teensy, but I have some familiarity with programming and soldering. I apologize if I'm posting in the wrong thread - this is a little bit of a beginner question, a little bit of an audio question, and a little bit of a "guidance" question.
I'd like to make a stand-in for a "Control Surface" - they cost too much, it doesn't make sense to me why.
Searching around on the forum, I've noticed two things about this subject - first, posters tended to feel strongly about also producing the motorized faders and secondly, I'm finding myself a little uncertain about the protocol (do control surfaces just use MIDI?)
Considering these damn things are $500, I'm wondering what the best route to my DAW's sliders might be. My thinking is that I don't really need the motors, but it seems like it might be worthwhile to use a resolution higher than MIDI messaging, if left to my own human-interface devices. There are some major questions about
Can anyone help get me started down this path? Thank you.