i want to gain easy access to the 18 or so pins on the underside of the 3.6pcb.
I use breadboard for prototyping then Vero (I know I know) for the finished article. I could solder fine wires to the pads and to pins on the end which could either be pushed into the breadboard or a corresponding pin header on the vero.
I wondered if the was a break out board available that I've not seen ?
I use breadboard for prototyping then Vero (I know I know) for the finished article. I could solder fine wires to the pads and to pins on the end which could either be pushed into the breadboard or a corresponding pin header on the vero.
I wondered if the was a break out board available that I've not seen ?