I am switching from an Arduino Duemilanove to the Teensy 2.0 for size.
I had the Ethercard library working with an ENC28J60 Ethernet Module with this pinout
ENC28J60------Arduino
1 Ground------Ground
2 Power-------VCC
3 Reset-------Reset
4 CS----------DigiPin 8
5 SCK---------DigiPin 13
6 SI----------DigiPin 11
7 SO----------DigiPin 12
I tried hook up to pins 8,11,12,13 on the teensy to make it work, but It doesn't seem to want to pull DHCP
On the teensy pins is this equivalent to the arduino pins from above?:
SCK=pb1
MOSI=pb2
MISO=pb3
INT0=pd5
also what would i need to change in the ethercard libs to point to the new pins?
I had the Ethercard library working with an ENC28J60 Ethernet Module with this pinout
ENC28J60------Arduino
1 Ground------Ground
2 Power-------VCC
3 Reset-------Reset
4 CS----------DigiPin 8
5 SCK---------DigiPin 13
6 SI----------DigiPin 11
7 SO----------DigiPin 12
I tried hook up to pins 8,11,12,13 on the teensy to make it work, but It doesn't seem to want to pull DHCP
On the teensy pins is this equivalent to the arduino pins from above?:
SCK=pb1
MOSI=pb2
MISO=pb3
INT0=pd5
also what would i need to change in the ethercard libs to point to the new pins?
Last edited: