May be pushing it too far. Using the Teensy as a HDMI, touch to usb converter?

[Swift Curse]

So i guess be for even getting into the project I have to ask some preliminary questions.

Can either the Teensy 2, 2++, or 3(preferred) support one of the following TFT LCD modules

• 7" inch TFT LCD module 800x480 SSD1963 w/touchpad PWM, arduino AVR STM32 ARM
• 5" 5.0" inch TFT LCD module Font IC 800x480 SSD1963 arduino DUE MEGA2560 3.5 7 3
• 7inch 7.0" 800*480 TFT LCD Module Display Touch Panel + SSD1963 For 51/AVR/STM32

If so, here is the idea.

Im looking to use one or two teensy's for this project.

1. With one teensy i would like to turn the TFT LCD into a screen that will support HDMI(preferred)/DVI/VGA support
2. The other teensy would allow the touch screen to be interfaced with a usb cord.

Possible or not?

[PaulStoffregen]

This is probably beyond the capability of any Teensy board.

[CheapB]

If you are just passing on the HDMI signal you could consider using a.....monitor, and then focus on the touch part. http://www.ebay.com/itm/Elo-Touch-In...item460c3f5f72

[Swift Curse]

@ PaulStoffregen - well that sucks

@cheapB - i've looked at those screens before and its just to big for my use.

[CheapB]

@cheapB - i've looked at those screens before and its just to big for my use.

If you can live with VGA instead of HDMI there are options using exactly the size and resolution you mentioned in the first post. This being a candidate: http://www.ebay.com/itm/LILLIPUT-COL...item4ac0e28113
but I am sure there are more.