Hello together,
I have a big problem: After uploading my latest sketch, the Teensy 3.0 is not recognized as USB device any more.
During the last upload of my sketch with the Teensy Loader, the program did show me that there was an error during upload.
Since that time, the device does not appear as Serial Com Port, I even tried on a second computer.
If I connect it to the USB cable, the little led blinks once and after a few seconds the color of my attached LCD display changes, so the teensy is not dead at all.
What I tried is to hold down the reboot button until the cable is connected and then release it, but still no recognition on my windows PC.
Is there a way to remove the corrupt sketch from the teensy ? Or can I reprogram the bootloader for example with an Arduino as ISP ?
Thanks for any help
I am really stuck here..
Wishes,
Max
I have a big problem: After uploading my latest sketch, the Teensy 3.0 is not recognized as USB device any more.
During the last upload of my sketch with the Teensy Loader, the program did show me that there was an error during upload.
Since that time, the device does not appear as Serial Com Port, I even tried on a second computer.
If I connect it to the USB cable, the little led blinks once and after a few seconds the color of my attached LCD display changes, so the teensy is not dead at all.
What I tried is to hold down the reboot button until the cable is connected and then release it, but still no recognition on my windows PC.
Is there a way to remove the corrupt sketch from the teensy ? Or can I reprogram the bootloader for example with an Arduino as ISP ?
Thanks for any help
I am really stuck here..Wishes,
Max
