My project will have more inputs than my board has pins.
Project Notes
Board: Teensy 3.0
Rotary Encoders turned by hand (no motors)
Questions:
1. Will encoders work if going through a 165?
2. If so, does the encoder library and debounce for the Teensy 3.0 still work? If not, what options would I have? I'm trying to avoid extra code and hardware to handle encoder and debounce.
3. Can I daisy chain 2 165s so that one will drive buttons and one will drive encoders or would I need to run each separately connected directly to the board?
4. Not related directly to this post, but what is the difference between a 165 and a 165N (as far as I would care about, or are they essentially the same for what I'm doing)?
Project Notes
Board: Teensy 3.0
Rotary Encoders turned by hand (no motors)
Questions:
1. Will encoders work if going through a 165?
2. If so, does the encoder library and debounce for the Teensy 3.0 still work? If not, what options would I have? I'm trying to avoid extra code and hardware to handle encoder and debounce.
3. Can I daisy chain 2 165s so that one will drive buttons and one will drive encoders or would I need to run each separately connected directly to the board?
4. Not related directly to this post, but what is the difference between a 165 and a 165N (as far as I would care about, or are they essentially the same for what I'm doing)?
Last edited: