Teensy 3.0 to Arduino R3 breakout board

[bboyes]

Sorry if this was mentioned in another thread and I missed it, but what is the name of the small connector for the solder pads under the Teensy 3.0? It is shown in this photo. Also, does this need hot air to solder it or will an iron do? I assume its easier on a bare board rather thaan one with pins already on it.

Samtec makes one: TSM-107-01-T-DV and it matches longer-reach header pins installed in the other through hole pads. Soldering iron works fine, as long as you have a fine tip.